![]()
On the monitor, after the BIOS screen you should see 1 or 2 single digits on the top left. Before you boot it back up, first REMOVE THE USB DRIVE, then start your NAS and see if it takes the firmware. Shutdown, boot up again and reverse the volumes in the instructions above.įinally you need to copy dom.img to the NAS local storage drive, type in this command:Ĭp dom.img /dev/sda (copies dom.img to the NAS local storage) Only if you cannot see dom.img or any contents of you USB stick then the drives are the other way around. If you can then SDB is definitely your USB stick and SDA is your NAS local storage drive. Type in ls to list directory and confirm you can see dom.img in the list. ![]() Mount /dev/sdb /root/usbdrive (this mounts your USB stick to the usbdrive folder we created)Ĭd /root/usbdrive (changes directory to the usbdrive directory) Mkdir usbdrive (this creates a new folder in /root called ‘usbdrive’) DEV/SDB1 or SDB2 etc.! We will confirm this in the following step, first you need to create a new folder, do this: YOUR USB may use a different mount point e.g. Look at the list of drives displayed, your USB stick will be SDB (/dev/sdb) and the NAS Local Flash Storage will be SDA (/dev/sda). Type in these commands at the shell prompt: REMEMBER: You may need to turn off Num Lock as it is enabled in the NAS BIOS by default! Double click it to launch a terminal shell session. Locate the console/terminal icon in top left of Puppy desktop. #QNAP MAC ADDRESS CHANGE AFTER UPDATE WINDOWS#Once in the GUI the fun really starts.Ĭlose off any windows that pop up by clicking OK/Kill until you can see the Puppy desktop. Switch on your NAS and allow it to boot into Precise Puppy, wait a few minutes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |